Hello, I am new here and am just getting into modding NERF blasters but I've run into a problem.
I have a Longstrike CS-6 White out that I have put the orange mod immortal kit on with the 7kg spring. I did it as a gift to my friend for X-mas (the blaster before this mod was inoperable). However now when I attempt to prime it with the default handle I BEND the priming mechanism (the piece the handle slips into) if I attempt to prime it using only one side.
During installation I did the following.
1- I removed all of the locks.
2- I cleaned up the interior as best I could
3- I used every piece of the immortal kit except extra parts.
4- After some struggling (The trigger catch spring kept slipping) I put it back together
I've considered doing a mod on the priming handle to ensure that equal pressure is being applied to either side of the handle but I have two problems with doing that right now.
1- I'm relatively broke and I didn't predict this to be an issue.
2- I am unsure how to do this really.
A lot of you guys are much more experienced at modding NERF blasters than I am. I would greatly appreciate any help you can offer.
Thank you
-Tac