I have an infinus that Im having issues with. I threw instructions of course. I wired in parallel to the stock battery a xt60 plug to run a 4 cell sub c NiCd pack and ran that on its own. So the voltage is 5.3ish off charger. I tried the blaster and seemed to fire ok maybe a little less boggy then stock. Now the issue is Ill use auto load feature and it will load a few and then stop. No led light push dart load switch wont start feeder flywheels wont rev. It wont cycle when you remove drum. You open and close jam door and it cycles and you can fire. Then same thing load a few and shut down. I then tried on alkaline without nicd and worked fine at 6.1v. So Im wondering if anyone knows does the blaster shit down with low voltage since 4 alkaline would likely never get much below 5v and thats why it works a few and quits loading. Firing with a loaded clip works fine on nicd just loading mech
↧