Okay, it's been a while.
While my limited access to the site has been a drawback, it has t stopped me from participating in the hobby!
I recently got hold of an old BuzzBee tek6, and I really liked the spring in it as opposed to the one in my EAT. While it fits nicely, I ran into some mechanical drawbacks.
The spring is a little short.
We all know very well that dead space is bad (cough cough reverse plunger)
But the spring is more than dead space. I'm only getting 5/8 of the power I can get out of it, and it seems to be grinding against my plunger rod a little bit too.
I need to make a spacer piece somehow, can somebody point me in the right direction?
I don't feel like buying a new spring, and that's not gonna happen for a while.
While my limited access to the site has been a drawback, it has t stopped me from participating in the hobby!
I recently got hold of an old BuzzBee tek6, and I really liked the spring in it as opposed to the one in my EAT. While it fits nicely, I ran into some mechanical drawbacks.
The spring is a little short.
We all know very well that dead space is bad (cough cough reverse plunger)
But the spring is more than dead space. I'm only getting 5/8 of the power I can get out of it, and it seems to be grinding against my plunger rod a little bit too.
I need to make a spacer piece somehow, can somebody point me in the right direction?
I don't feel like buying a new spring, and that's not gonna happen for a while.