95 Crossbow Clip Fed?

{Before note: Typing this out on an iPad so please forgive any mistakes}

Hello.

I have been studying CaptainSlug's Caliburn homemade, how nerf clip fed blasters work, and how we could make a clip fed nerf crossbow.
Several people will say "we dont need this" and "this isnt an improvement", and they may be right. However heres what I put to them: Imagine a 35 round drum in a 95 crossbow. I dont know about you, but I think that would be at the least cool, if not badass.

There is certainly more then a few problems with getting a clip onto this icon, so lets list them step by step.

1. priming and dart stop: The crossbow and all of the homemade internals ive seen are pull back and fire, not pull back, push fowards, then fire like current mag/clip fed nerf blasters. (Original Picture credit to Slug)
This is what I propose:



2. structural support: I was thinking we could use the stock barrel's leftover "scope" as structural support by sticking a long rod (heh) into it from the magazine mech, overnthe top of the blaster (as shown above by that big pink stick on the top of the blaster)

3. Acessing the mechanism to make repairs: there is no doubt that this idea would need an occasional fix. We could use screws if we wanted, or maybe we could use one screw then the whole thing comes off the crossbow. Advice needed on this.

4. Materials and production via a guide: I was thinking delrin, aluminum, or ploycarb for the case of the inner mechanism. However I dont have experience in deciding materials, so advice needed here too.

This whole project is in the design phase, not in the prototype phase yet. So any advice/input/help is thanked and will be looked into.

Total size:



Thanks!
-silly